OPEN MIND

The optimal tilt strategy based on machine kinematics and geometry

hyperMILL® CAM software offers 5-axis milling with a fixed tool angle, automatic indexing and simultaneous machining. The optimal tilt strategy can be selected based on the machine kinematics and geometry.

Multi-axis indexing with fixed tool inclination

Moving and tipping of the workplane allows parts to be machined from different directions without reclamping. The direction of machining corresponds to the orientation of the cutting tool. Programming times are reduced with trans­for­mation functions supporting shifted or tilted workplanes.

Milling with fixed option 3+2

For 3D machining with a tool that is tilted relative to the machining direction, milling areas can be easily programmed and defined without overlaps and gaps, and checked for collisions. This strategy ensures that all areas are fully calculated.

Automatic indexing

Automated 3+2 machining is a feasible alternative if the machine tool does not facilitate full 5-axis simultaneous milling. Large areas that require various tool angles can be programmed and milled in a single operation. The automatic indexing feature scans for fixed tool incli­na­tions and the corresponding tool paths. If there are potential toolholder collisions, the respective path segment can be sub-divided automatically into smaller segments with the corresponding tool positions.

5-axis simultaneous machining

This 5-axis machining cycle is the efficient alternative to conventional 3+2 milling for machining on or near steep walls. Similarly, a tool tilt to the Z-axis is predefined and collision-free, if possible. The continuous movement of the tool around the Z-axis is either automatically calculated by hyperMILL® or calculated as a result of defined tilt curves. Possible collisions are automatically detected and avoided by changing the tool angle. Optimized tool tilt angles improve cutting conditions when milling surfaces.

mobile-s mobile-m mobile-l tablet desktop-s desktop-m desktop-l desktop-xl